Eagle 2 post lift manual

Motor runs, but unit will not build hydraulic pressure Solenoid valve manual override is open Some of our units (Option 2) are equipped with a two position valve with a mechanical manual override (Item A). With stem of valve pointing up, push down and turn clockwise until stem won’t turn, and let go. Valve is now closed. Any use of the lift by operators who are not familiar with the instructions and procedures contained herein is unauthorized. Manual Keeping For a proper use of this manual, the following is recommended: • Keep the manual near the lift, in an easily accessible place. • Keep the manual in an area protected from the damp. -2 INSTALLATION MANUAL CONTENTS TPA LIFT Parts Checklist Installation Instructions Step 1 Measure lift area and check for defects Step 2 Cylinder assembly Step 3 Position columns and uprights, level columns and install top beam Step 4 Install anchor bolts and re-level columns Step 5 Install and adjust cables.

Important Lift Maintenance: Lift CablesMaintaining your lift cables is vital because they are a major part of the lifting process. They ensure that the vehic. See all of the lifts we carry at www.doorway.ru Parts Checklist Notes about your Eagle@ Lift. Installation Instructions - Step 1 Measure lift area and check for defects Step 2 Cylinder assembly TP/lPO-SA.

level, post base shims may be required and can be purchased from Eagle Lift. Note: Before you lay out your lift, make sure you allow room for a forklift to move heavy parts into the area. Read this manual thoroughly before installing, operating, or maintaining this lift. 2. Site Evaluation and Lift Location: A. Always use an architect’s plan when provided. Before unpacking the lift entirely, determine if the site is adequate for the lift model being installed see figures 2 3 for typical bay layout and ceiling height. 1. Read this manual thoroughly before installing, operating, or maintaining this lift. 2. This lift is designed for indoor use only, and should not be installed in a pit or depression. 3. The floor on which the lift is to be installed must be 4-¼” inch minimum thickness concrete, with a mini.