Catalyst X and X Switch Software Configuration Guide, Release (55)SE 12/Aug/ Catalyst X and X Switch Software Configuration Guide, Release (53)SE2 10/May/ Cisco IOS Software Installation Document, Cisco IOS Release (53)SE2 and Later 13/Jan/ · Always use a Cisco-approved StackPower cable to connect the switches. Note The Catalyst X S-PWR ports accept either the yellow or the green end of the StackPower cable. Align the connector and connect the StackPower cable to the S-PWR port on the switch rear panel and finger-tighten the screw. Catalyst X and X Switch Hardware Installation Guide OL Chapter 3 Power Supply and Fan Module Installation Installing a Fan Module. Installing a Fan Module. NoteThere must be a fan module in both fan module slots. Step 1Pinch the fan release handle, and slide the fan out.
Cisco Catalyst X Series Switches Data Sheet. Cisco ® Catalyst ® X and X Series Switches are an enterprise-class lines of stackable and standalone switches, respectively. These switches provide high availability, scalability, security, energy efficiency, and ease of operation with innovative features such as Cisco StackPower (available only on the Catalyst X), IEEE at. Cisco X Series. Cisco Catalyst X Switches are enterprise-class, stackable switches. They provide high availability, scalability, security, energy efficiency, and ease of operation with innovative features such as Cisco StackPower, IEEE at PoE+, optional network modules, redundant power supplies, and MACsec features. Book Title. Catalyst X and X Software Configuration Guide, Release (1)SE. Chapter Title. Configuring MACsec Encryption. PDF - Complete Book ( MB) PDF - This Chapter ( KB) View with Adobe Reader on a variety of devices.
The Cisco ® Catalyst ® X and X Series Switches are an enterprise-class lines of stackable and standalone switches, respectively. These switches provide high availability, scalability, security, energy efficiency, and ease of operation with innovative features such as Cisco StackPower (available only on the Catalyst ‑X), IEEE at Power over Ethernet Plus (PoE+) configurations, optional network modules, redundant power supplies, and Media Access Control Security (MACsec. A Catalyst Switch Hardware Installation Guide OL Appendix A Technical Specifications. AC input voltage to VAC (autoranging) to 3 A, 50 to 60 Hz DC input voltages for RPS and +12 V @ A Power consumption W Power dissipation W, BTUs per hour Power rating kVA. Each of the Catalyst PS switch 10/ ports or the Catalyst GPS switch 10// ports can deliver up to W of PoE. On the Catalyst PS or GPS switches, any 24 of the 48 10/ or 10// ports can deliver W of PoE, or any combination of the ports can deliver an average of W of PoE at the same time, up to a maximum switch power output of W.
0コメント